Mechanical Edge Finder
► Ø 10 straight shank can be installed directly on milling chuck or drilling chuck. (see fig. 1).
► Slightly press on the edge of sensor unit to make it eccentric at 0.5mm (see fig. 2).
► Rotate with speed of 400 ~ 600 rpm.
► Make sensor unit contact to the end face of workpiece as shown Fig. 2, then move steadily until turning into Fig. 3 looks keep still. When making fine-moving and it looks as Fig. 4, and this coordinate position is the basis point.
► The position of end face of the workpiece is the coordinate position of sensor unit plus radius 5mm.
► Slightly press on the edge of sensor unit to make it eccentric at 0.5mm (see fig. 2).
► Rotate with speed of 400 ~ 600 rpm.
► Make sensor unit contact to the end face of workpiece as shown Fig. 2, then move steadily until turning into Fig. 3 looks keep still. When making fine-moving and it looks as Fig. 4, and this coordinate position is the basis point.
► The position of end face of the workpiece is the coordinate position of sensor unit plus radius 5mm.
